Non-Menu Commands

- descent2.com
	[ Search ]
	Last Updated: 05/27/99

Polytron32 Manual - written by Steve Klinger

Non-Menu Commands

Following is a list of all the Polytron32 non-menu commands.

Two Dimensional View Controls

Key Command	Description
[A] [Pgup]	Zoom In
[Z] [Y] [Pgdn]	Zoom Out
]	Increase Grid Snap Frequency
[	Decrease Grid Snap Frequency
{	Increase Grid Line Frequency
}	Decrease Grid Line Frequency
[Left Arrow]	Shift View to the Right
[Right Arrow]	Shift View to the Left
[Up Arrow]	Shift view down
[Down Arrow]	Shift view up
[Home]	Centers the polymodel in the currently focused view

Isometric View Controls

Key Command	Description
[Up Arrow]	Rotate Up (Wireframe Mode)
[Down Arrow]	Rotate Down (Wireframe Mode)
[Left Arrow]	Rotate Left (Wireframe Mode)
[Right Arrow]	Rotate Right (Wireframe Mode)
[A] [Pgup]	Zoom In
[Z] [Y] [Pgdn]	Zoom Out

Point/Polygon Movement

Key Command	Description
[Numpad 2]	Move Point/Polygon Down in focused view.
[Numpad 4]	Move Point/Polygon Left in focused view.
[Numpad 6]	Move Points/Polygons Right in focused view.
[Numpad 8]	Move Points/Polygons Up in focused view.
[Numpad +]	Move Points/Polygons in + direction unseen in focused view.
[Numpad -]	Move Points/Polygons in - direction unseen in focused view.

Point Movement (XY Move Mode)

Key Command	Description
[Numpad 2]	Move Point/Polygon in - Y direction.
[Numpad 4]	Move Point/Polygon in - X direction.
[Numpad 6]	Move Points/Polygons in +X direction.
[Numpad 8]	Move Points/Polygons in + Y direction.
[Numpad +]	Move Points/Polygons in + Z direction.
[Numpad -]	Move Points/Polygons in - Z direction.

Point/ Polygon Selection

Key Command	Description
[I]	Cycles through points on current polygon.
[Shift-I]	Cycles through points on current polygon in reverse order.
[U]	Cycles through all points.
[Shift-U]	Cycles through all points in reverse order.
[L]	Cycles through polygons relative to the current point.
[Shift-L]	Same as above but in reverse order.
[K]	Cycles through all polygons.
[Shift-K]	Cycles through all polygons in reverse order.

Mouse Functions - 2d View Functions

Command sequence	Description
[Left-Click]	Selects a point and makes it current.
[Right-Click]	Selects a polygon and makes it current.
[Ctrl-Left-Click]	Marks a point or set of points by drawing a box around them.
[Ctrl-Right-Click]	Marks a polygon or set of polygons by drawing a box around them.
[Shift-Left-Drag]	Drags a point to a new location.

PMV Preview Controls

Key Command	Description
[Ctrl-Mouse-Move]	Rotate Model (Texture modes)
[Shift-Mouse-Move]	Zoom View (Texture Modes)

Mouse Commands - Texture Alignment Display Functions

Key Command	Description
[Left-Click]	Selects UV point of current Texture Polygon.
[Shift-Left-Drag]	Moves the current UV Point.
[Shift-Right-Drag]	Moves the entire Texture Polygon.
[Ctrl-Right-click]	Enables mouse to move UV points in Texture Alignment view.

Back

Next

WebHits counts accesses on this page since 02/08/97. View detailed statistics!